Használati útmutató CRUX SWRNS-63S

Olvassa el alább 📖 a magyar nyelvű használati útmutatót CRUX SWRNS-63S (2 oldal) a nincs kategorizálva kategóriában. Ezt az útmutatót 12 ember találta hasznosnak.

Crux Interfacing Solutions • Chatsworth, CA 91311

phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com

rev.083122

SWRNS-63S

Radio Replacement with Steering Wheel Control Retention

for Select NISSAN Vehicles

1 of 2

ROP LATADI RECE MEN

SWETIONC RENT

+

R

INTERFACING SOLUTIONS

- Pre-programmed to retain factory Steering Wheel Controls.

- Includes antenna adapter.

PRODUCT FEATURES:

PARTS INCLUDED:

SWRNS-63S HarnessAntenna Adapter

INSTALLATION DIAGRAM:

AFTERMARKET

RADIO

+12V Constant Yellow

+12V ACC Red

Ground Black

Illumination Orange

Not Used Orange/White

Amp Turn On Blue/ White

Right Front (+) Gray

Right Front (-) Gray/Black

Left Front (+) White

Left Front (-) White/Black

Right Rear (+) Violet

Right Rear (-) Violet/Black

Left Rear (+) Green

Left Rear (-) Green/Black

VSS (Vehicle Speed Signal) Brown

Chassis Ground Black

Reverse Output Red/White or Violet/White

(with Ring Terminal)

TO FACTORY

HARNESS

12-Pin Black

Connector

BLUE/ Power Antenna

4-Pin

Connector

32 PIN

20 PIN

Yellow RCA

(Retain OE Camera)

Rear View Camera Signal

SWRNS-63S MODULE

Option A:

Option B:

Cap or insulate if

not being used

BLUE / YELLOW

Insulate with tape

if not being used

3.5MM SWC CABLES (Option A or B)

Use the proper 3.5MM to 4-Pin cable for your radio.

Plug in the selected 3.5MM SWC cable to the 4-pin port

on the module. See “DIP SWITCH SETTINGS” section.

To aftermarket

radio SWC wire

or 3.5mm port

1 2 3

ON

SWC Cables

Termékspecifikációk