Használati útmutató Doepfer A-105

Oldalak 16 Engels nincs kategorizálva

Olvassa el ingyen online a(z) Doepfer A-105 használati útmutatóját, vagy töltse le PDF-ben. Az útmutatót 22 ember találta hasznosnak. Kérdése van a modellről? Tegyen fel kérdést

doepfer System A - 100A-105 / A-122
1
1. Introduction
The modules A-105 and A-122 are voltage-
controlled low-pass filters, which filter out the higher
parts of the sound spectrum, and lets lower frequen-
cies pass through.
The cut-off frequencydetermines the point at which
filtering takes effect. You can control this manually, or
by voltage control (filter modulation, for instance by
an LFO). Two CV inputs are available. The cut-off
slope is -24 dB/octave.
Voltage controlled resonance: for both A-105 and
A-122, resonance can be controlled not just manually,
but by voltages as well, right up to self-oscillation. In
this case, the filter behaves like a sine wave oscillator.
The A-105is based on the special circuit SSM2044,
that was used in several devices of the companies
Korg (Polysix, Mono-Poly), Sequential Circuits
(Prophets, Pro-One), PPG, Fairlight, Emu and Kawai.
The circuitry of the A-122uses a Curtis CEM 3320
chip, and is very similar to the classic Oberheim filter
sound. Because of the different circuits the A-105 and
A-122 have considerably different sounds and even
sound different compared to the other filters (e.g.
A-120 Moog-type low pass, A-102 Diode Low Pass or
A-103 18dB low pass, A-124 Wasp filter).
As the functions and controls are the same for both
modules they are a combined in one manual.
FCV 1
Resonance
FCV 2
QCV
Audio
In
Level
Audio
Out
QCV
Frequency
A-122
VCF 3
FCV 2

Értékelje ezt az útmutatót

Termékspecifikációk

Márka: Doepfer
Kategória: nincs kategorizálva
Modell: A-105

Szüksége van segítségre?

Ha segítségre van szüksége Doepfer A-105, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek