Használati útmutató Doepfer A-140-2v

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Doepfer A-140-2v (4 oldal) a nincs kategorizálva kategóriában. Ezt az útmutatót 15 ember találta hasznosnak és 6 felhasználó értékelte átlagosan 4.5 csillagra

A-140-2 Dual ADSR

Position and function of the jumpers and connectors Board A

• The picture shows the factory setting of the jumpers.

• To change the polarity of the second output (Output 2) the position of JP6/JP9 has to be changed.

• To disconnect the unit from the gate signal on the bus JP11/JP10 has to be removed.

• To change the direction of the time control voltage CVT (i.e. if an increasing CV increases or decreases the

time parameters) the position of JP7/JP4 has to be changed

• If a parameter (A, D, R) should be removed from the CVT control the jumper in question has to be removed

• Normally Systain is not affected by CVT (as it's not a time parameter) and the corresponding jumper is not

installed in the factory. If voltage control of Sustain is desired the corresponding jumper has to be installed

on the position "S" of JP8/JP5.

JP11/JP10:

Bus Gate

JP9/JP6: Polarity of Output 2

upper position = inverted

lower position = non-inverted

JP7/JP4: Time CV Polarity

upper position = inverted

lower position = non-inverted

JP8/JP5: Time CV assignment

when jumper installed the corresponding

parameter (A, D, S, R) is CV controlled

JP1:

Bus Connecto

r

ADSR #2 ADSR #1

Termékspecifikációk