Használati útmutató Alula RE205

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Alula RE205 (2 oldal) a nincs kategorizálva kategóriában. Ezt az útmutatót 18 ember találta hasznosnak és 9.5 felhasználó értékelte átlagosan 4.9 csillagra

Oldal 1/2
The Temperature Sensor is used to detect freeze and
overheat conditions. The sensor will alarm when the
temperature trip points are reached.
Features
Indicates freeze and overheat warnings
Industry-leading wireless range and battery life
Secure encrypted wireless transmissions
5-year warranty
Enroll by placing the panel into wireless enrollment mode
and then sending an enrollment signal from the sensor.
Options for sending an Enrollment Signal
Remove the battery tab and cover to
trip tamper. Select desired Loop:
Loop 1: Overheat
Loop 2: Magnetic reed (magnet
not included)
Loop 3: Freeze
Loop 4: Tamper
Install by mounting the sensor in the desired location
using two #4 or #6 screws. An optional cover-securing
screw is included. Alternatively, the sensor can also be
installed using 3M™ VHB™ tape.
Freeze or Heat alarms are transmitted when the
temperature trip points are reached.
Temperature Trip Points
Heat alarms when over 100°F (38°C)
Heat restores when under 97°F (36°C)
Freeze alarms when under 45°F (7°C)
Freeze restores when over 48°F (9°C)
Use the panel installation guide to verify proper system setup.
Mounting Screw Holes
RE205 Temperature Sensor
Honeywell
®
Compatible
I
N
S
T
A
L
L
G
U
I
D
E
I
Cover-Securing Screw Hole
Resolution Compatibles
Pro Tips
3M™ VHB™ Tape works great if the surface is properly prepared and rm pressure is
applied for over 10 seconds.
Surface Preparation
Clean the surface
Ensure the mounting surface temperature is above 50°F

Termékspecifikációk

Márka: Alula
Kategória: nincs kategorizálva
Modell: RE205

Szüksége van segítségre?

Ha segítségre van szüksége Alula RE205, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek