Használati útmutató Axxess XSVI-1788-NAV

Olvassa el alább 📖 a magyar nyelvű használati útmutatót Axxess XSVI-1788-NAV (3 oldal) a nincs kategorizálva kategóriában. Ezt az útmutatót 14 ember találta hasznosnak és 9 felhasználó értékelte átlagosan 4.6 csillagra

INSTXSVI-1788-NAV

© COPYRIGHT 2004-2013 METRA ELECTRONICS CORPORATION

1-800-221-0932metraonline.com

REV. 9/8/14

INSTXSVI-1788-NAV

© COPYRIGHT 2004-2013 METRA ELECTRONICS CORPORATION

1-800-221-0932metraonline.com

REV. 9/8/14

INSTXSVI-1788-NAV

© COPYRIGHT 2004-2013 METRA ELECTRONICS CORPORATION

1-800-221-0932metraonline.com

REV. 9/8/14

INSTXSVI-1788-NAV

© COPYRIGHT 2004-2013 METRA ELECTRONICS CORPORATION

1-800-221-0932metraonline.com

REV. 9/8/14

KNOWLEDGE IS POWER

Enhance your installation and fabrication skills by

enrolling in the most recognized and respected

mobile electronics school in our industry.

Log onto www.installerinstitute.com or call

800-354-6782 for more information and take steps

toward a better tomorrow.

Metra recommends MECP

certified technicians

•ConnecttheBluewiretotheantennaturnonwireoftheaftermarketradio.

•ConnecttheWhitewiretotheleftfrontpositivespeakeroutputofthe

aftermarketradio.

•ConnecttheWhite/Blackwiretotheleftfrontnegativespeakeroutputofthe

aftermarketradio.

•ConnecttheGraywiretotherightfrontpositivespeakeroutputofthe

aftermarketradio.

•ConnecttheGray/Black wiretotherightfrontnegativespeakeroutputofthe

aftermarketradio.

•ConnecttheGreenwiretotheradio’sleftrearpositivespeakeroutput.

•ConnecttheGreen/Blackwiretotheradio’sleftrearnegativespeakeroutput.

•Connectthe Purplewiretotheradio’srightrearpositivespeakeroutput.

•Connectthe Purple/Blackwiretotheradio’srightrearnegativespeakeroutput.

Thefollowingwiresarefortheaftermarketradiosthathavenavigationbuiltin.

•Connectthe Light Greenwiretotheparkingbrakewireoftheaftermarket

navigationradio(ifapplicable).

•ConnecttheBlue/PinkwiretotheVSSorspeedsensewireoftheaftermarket

navigationradio(ifapplicable).

•Connectthe Green/Purplewiretothereversewireoftheaftermarketnavigation

radio(ifapplicable).

•Cyclethekeybyturningtheignitiononfor30seconds,then“off”and“on”againto

testtheradio.

ASWC-1 (if installing)

AftertheXSVIisinitialized,plugintheASWC-1intothe12pinharnessofthe

XSVI-1788-NAVandrefertotheASWC-1instructions.

FEATURES

•Providesaccessory(12-volt10-amp)

•RetainsR.A.P.(retainedaccessorypower)

•ProvidesNAVoutputs(parkingbrake,reverse,andV.S.S.)

•PrewiredASWC-1harnessincluded(ASWC-1soldseparately)

•Highlevelspeakerinput

•USBupdatable

XSVI-1788-NAV

Dodge/Mercedes/Freightliner accessory and

NAV output CAN harness 2008-up

DODGE

Sprinter (sound 20/50 radio)2008-2009

MERCEDES

Sprinter(sound 20/50 radio) 2010-up

FREIGHTLINER

Sprinter (sound 20/50 radio) 2008-up

APPLICATIONS

Connections to be made

•ConnecttheYellowwiretotheradio’s12voltbatteryormemorywire.

•ConnecttheBlackwiretotheradio’sgroundwire.

•ConnecttheRedwiretotheignitionwireoftheaftermarketradio.

•ConnecttheOrangewiretotheilluminationwireoftheaftermarketradio.Ifthe

aftermarketradiohasnoilluminationwire,tapeofftheOrangewire.

Caution: Metra recommends disconnecting the negative battery terminal before beginning

any installation. All accessories, switches, and especially air bag indicator lights must be

plugged in before reconnecting the battery or cycling the ignition.

*Note: Refer also to the instructions included with the aftermarket radio.

KNOWLEDGE IS POWER

Enhance your installation and fabrication skills by

enrolling in the most recognized and respected

mobile electronics school in our industry.

Log onto www.installerinstitute.com or call

800-354-6782 for more information and take steps

toward a better tomorrow.

Metra recommends MECP

certified technicians

•ConnecttheBluewiretotheantennaturnonwireoftheaftermarketradio.

•ConnecttheWhitewiretotheleftfrontpositivespeakeroutputofthe

aftermarketradio.

•ConnecttheWhite/Blackwiretotheleftfrontnegativespeakeroutputofthe

aftermarketradio.

•ConnecttheGraywiretotherightfrontpositivespeakeroutputofthe

aftermarketradio.

•ConnecttheGray/Black wiretotherightfrontnegativespeakeroutputofthe

aftermarketradio.

•ConnecttheGreenwiretotheradio’sleftrearpositivespeakeroutput.

•ConnecttheGreen/Blackwiretotheradio’sleftrearnegativespeakeroutput.

•Connectthe Purplewiretotheradio’srightrearpositivespeakeroutput.

•Connectthe Purple/Blackwiretotheradio’srightrearnegativespeakeroutput.

Thefollowingwiresarefortheaftermarketradiosthathavenavigationbuiltin.

•Connectthe Light Greenwiretotheparkingbrakewireoftheaftermarket

navigationradio(ifapplicable).

•ConnecttheBlue/PinkwiretotheVSSorspeedsensewireoftheaftermarket

navigationradio(ifapplicable).

•Connectthe Green/Purplewiretothereversewireoftheaftermarketnavigation

radio(ifapplicable).

•Cyclethekeybyturningtheignitiononfor30seconds,then“off”and“on”againto

testtheradio.

ASWC-1 (if installing)

AftertheXSVIisinitialized,plugintheASWC-1intothe12pinharnessofthe

XSVI-1788-NAVandrefertotheASWC-1instructions.

FEATURES

•Providesaccessory(12-volt10-amp)

•RetainsR.A.P.(retainedaccessorypower)

•ProvidesNAVoutputs(parkingbrake,reverse,andV.S.S.)

•PrewiredASWC-1harnessincluded(ASWC-1soldseparately)

•Highlevelspeakerinput

•USBupdatable

XSVI-1788-NAV

Dodge/Mercedes/Freightliner accessory and

NAV output CAN harness 2008-up

DODGE

Sprinter (sound 20/50 radio)2008-2009

MERCEDES

Sprinter(sound 20/50 radio) 2010-up

FREIGHTLINER

Sprinter (sound 20/50 radio) 2008-up

APPLICATIONS

Connections to be made

•ConnecttheYellowwiretotheradio’s12voltbatteryormemorywire.

•ConnecttheBlackwiretotheradio’sgroundwire.

•ConnecttheRedwiretotheignitionwireoftheaftermarketradio.

•ConnecttheOrangewiretotheilluminationwireoftheaftermarketradio.Ifthe

aftermarketradiohasnoilluminationwire,tapeofftheOrangewire.

Caution: Metra recommends disconnecting the negative battery terminal before beginning

any installation.All accessories, switches, and especially air bag indicator lights must be

plugged in before reconnecting the battery or cycling the ignition.

*Note: Refer also to the instructions included with the aftermarket radio.

Termékspecifikációk