Használati útmutató AXESS AXLOC-150A

Olvassa el alább 📖 a magyar nyelvű használati útmutatót AXESS AXLOC-150A (3 oldal) a nincs kategorizálva kategóriában. Ezt az útmutatót 18 ember találta hasznosnak.

/ 3 PDF

AXLOC-150A

INSTALLATION INSTRUCTIONS

REV. 12/18/19

© COPYRIGHT 2019 METRA ELECTRONICS CORPORATION

Integrate • AxxessInterfaces.com

Wire Color & Function: The audio and power input wire colors are an EIA standard for

car stereo applications as follows.

Note: Be sure that all audio input connections are polarized or in phase with each other.

That is, the positive output wires from the audio source need to be connected to the

corresponding positive input wires of the AXLOC-150A. The same goes for the negative

audio wires. Failure to do this will result in poor bass response and low quality audio.

Adjusting the AXLOC-150A for maximum performance:

After completing all of the necessary connections, turn the AXLOC-150A adjustment pots all of the

way down by rotating them completely counter-clockwise. Now, turn the stereo system on and

adjust the main volume control on the stereo to approximately 3/4 maximum volume. Select

one of the adjustment pots on the AXLOC-150A and turn it slowly clockwise until you notice audio

distortion and then stop. Turn the remaining pot to the same position as the previously adjusted

pot. The audio set-up of the AXLOC-150A is now complete and ready to be enjoyed.

INPUT HARNESS

White = LEFT Front (+) Input

White/Black = LEFT Front (-) Input

Black = Reference Ground (-)

(Reference ground optional if noise is present)

Gray = RIGHT Front (+) Input

Gray/Black = RIGHT Front (-) Input

Termékspecifikációk