Használati útmutató AXESS AXLOCM-80

Olvassa el alább 📖 a magyar nyelvű használati útmutatót AXESS AXLOCM-80 (3 oldal) a nincs kategorizálva kategóriában. Ezt az útmutatót 15 ember találta hasznosnak és 7 felhasználó értékelte átlagosan 4.6 csillagra

AXLOCM-80

INSTALLATION INSTRUCTIONS

REV. 12/13/19© COPYRIGHT 2019 METRA ELECTRONICS CORPORATION

Integrate • AxxessInterfaces.com

The LOC is designed to convert (2) channels of speaker level audio into (2) channels of line

level audio that can be used by OEM amplifiers. It can also be used with OEM radios to add

aftermarket amplifiers. This device will also detect the presence of an audio signal and then

generate a +12V output that can be used to turn-on an aftermarket amplifier.

Features and specifications

The LOC is able to handle 40 watts per channel continuous input without overheating. The

input circuitry is designed to correct the crossover distortion commonly found on standard

LOC's, while providing a high to low level step down of 6:1. Output audio level is adjustable

using the onboard, high quality potentiometers. The remote output or amplifier trigger

is rated at 500mA (+12V) and will easily handle an outboard relay if additional current is

needed. The remote output will trigger instantaneously when the LOC detects a DC voltage

on the white, left + audio input wire above 5V or a very low audio signal. It will shut off 60

seconds after no signal is detected.

Installation

The LOC should be installed on a stereo’s speaker output wires, or the output wires on an

OEM amplifier of up to 40 watts per channel. These wires can be found behind the stereo in

the dash, on the output of an OEM amplifier, or on the input terminals on the OEM speakers.

Please refer to the wiring diagram for the input connection details.

(Continued on other side)

2 Channel Adjustable, Line Output Converter (LOC)

with Built-in Amplifier Remote Generator

Termékspecifikációk