Használati útmutató AXESS HYBL-05

Olvassa el alább 📖 a magyar nyelvű használati útmutatót AXESS HYBL-05 (8 oldal) a nincs kategorizálva kategóriában. Ezt az útmutatót 10 ember találta hasznosnak és 5.5 felhasználó értékelte átlagosan 4.7 csillagra

Oldal 1/8
INSTALLATION INSTRUCTIONS FOR PART HYBL-05
METRA. The World’s best kits.
metraonline.com1-800-221-0932
© COPYRIGHT 2004-2011 METRA ELECTRONICS CORPORATION
REV. 7/24/2013 INSTHYBL-05
CAUTION: Metra recommends disconnecting the
negative battery terminal before beginning any
installation. All accessories, switches, and especially
reconnecting the battery or cycling the ignition.
NOTE: Refer to the instructions included with the
aftermarket radio.
• RetainsfactoryBluelink
• Providesnavigationoutputs
• USBupdatable
• Retainsfadeandbalance
• Usedinnon-amplifiedsoundsystems
• Retainsfactorybackupcamera
• Retainsfactory3.5mmjack
• Highlevelspeakerinput
• PrewiredASWC-1harnessincluded(ASWC-1soldseparately)
KIT FEATURES
•Cuttingtool•Crimpingtool•Tape•Connectors
(example:butt-connectors,bellcaps,etc.)
TOOLS REQUIRED
Hyundai Veloster Blue Link interface
2011-up
HYBL-05
APPLICATIONS
•HYBL-05Interface•16-pinharnesswith
strippedleads•18-pinto24-&18-pinconnector
INTERFACE COMPONENTS
HYUNDAI
Veloster 2011-up
HYBL-05
2
• Connectthe wiretothegroundwireoftheaftermarketradio.Black
• Connectthe wiretothepowerantennawireoftheaftermarketBlue
radio.Iftheaftermarketradiodoesnothaveapowerantennawiretape
offthe wire.Blue
• Connectthe wiretotheilluminationwireoftheaftermarketradio.Orange
Iftheaftermarketradiohasnoilluminationwire,tapeoffthe wire.Orange
• Connectthe wiretotheparkingbrakewireoftheaftermarketLight Green
navigationradio.
• Co
nnectthe and RCAtotheaftermarketradiosAUXinput.White Red
From the 2nd 24-pin harness:
• ConnecttheYellowRCAtothevideoinoftheaftermarketradio.
From the 18-pin harness:
• Connectthe wiretotheVSSorspeedsensewireoftheaftermarketBlue/Pink
navigationradio.
• Connectthe wiretothereversewireoftheaftermarketGreen/Purple
navigationradio.
• Connectthe wiretotheradio’sleftrearpositivespeakeroutput.Green
• Connectthe wiretotheradio’sleftrearnegativespeakeroutput.Green/Black
From the 16-pin harness with stripped leads:
• Connectthe wirestotheignitionwireoftheaftermarketradio.Red
• Connectthe wiretotheleftfrontpositivespeakeroutputoftheWhite
aftermarketradio.
• Connectthe wiretotheleftfrontnegativespeakeroutputoftheWhite/Black
aftermarketradio.
• Connectthe wiretotherightfrontpositivespeakeroutputoftheGray
aftermarketradio.
• Connectthe wiretotherightfrontnegativespeakeroutputoftheGray/Black
aftermarketradio.
• Connectthe wiretothemutewireoftheaftermarketradio.IftheBrown
aftermarketradiodoesnothaveaMutewire,tapeupthe wire.Brown
• The willnotbeusedinthisapplication.Blue/Pink
• The wirewillnotbeusedinthisapplication.Green/Purple
• The wirewillnotbeusedinthisapplication.Orange/White
• The wirewillnotbeusedinthisapplication.Light Green
From the 1st 24-pin harness:
• ConnecttheYellowwiretothe12-voltconstant/batterywireof
theaftermarketradio.
Connections to be made
HYBL-05
3
Connections to be made
• Connectthe wiretotheradio’srightrearpositivespeakeroutput.Purple
• Connectthe wiretotheradio’srightrearnegativePurple/Black
speakeroutput.
Testing and adjusting the HYBL-05
1. Turntheaftermarketradioon.
2. Setpotentiometerallthewaytotheleft.
3. Setradiotodesiredlevel.
4. Adjustthepotentiometertotherightuntiltheradio’saudiolevelishigh
andfreeofdistortion.
5. TestBlueLink.
6. Reassembledashandenjoyyournewradio.
Additional 12-pin harness (ASWC-1 harness)
This12-pinharnessistobeusedinconjunctionwiththeASWC-1(notincluded).
PleaserefertoASWC-1instructionsforprogramming.
Installing the HYBL-05
Installing the HYBL-05
1. Withalltheconnectionscompleted,plugthe16-and18-pinharnesses
intotheHYBL-05.
2. Plugthe24-&18-pinharnessintothevehiclesideharness,andplugthe
aftermarketradioharnessintotheaftermarketradio.
3. Reconnectthenegativebatteryterminal.
4. Turntheignitionon,butdonotstartthecar.
5. Pressandholdthevolumeupbuttononthesteeringwheelfor5-seconds,
thiswilllearnBlueLink.
6. Ifthevehiclecameequippedwithfactorynavigationpressandholdthemode
buttononthesteeringwheelfor5-seconds(Ifvehicledidnotcomeequipped
withfactorynavigation,skipthisstep).
Installing the HYBL-05

Termékspecifikációk

Márka: AXESS
Kategória: nincs kategorizálva
Modell: HYBL-05

Szüksége van segítségre?

Ha segítségre van szüksége AXESS HYBL-05, tegyen fel kérdést alább, és más felhasználók válaszolnak Önnek